In the majority of cases, most individuals spend quite a lot of money purchasing their forklift. Hence, it is really important to take proper care of it so as to protect your investment well into the long run. It is a good idea to know the procedures which are undertaken in maintaining and taking care of this equipment.
One of the best ways to tell how good the engine is running is by starting the forklift up and listening closely to see how it works. For example, if there are any knocks or misses, the machinery is defective and this must raise some concerns. Furthermore listen carefully for any squealing noise that come from the belts because these sounds will provide you with a wealth of information.
Some of the main components requiring attention during maintenance comprise the safety warning devices, gauges, horn, the overhead guard and the lights. Any burnt out light bulbs or faulty parts must be replaced as soon as they are noticed. It is also imperative to inspect the wiring.
After the above components have been checked carefully, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Each cell of the battery should be inspected so as to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter should be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change is done and the filters have been replaced, a visual inspection of the drive axle needs to be done. If there is a grease fitting on the axle make certain to apply some grease. Check the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, check every other part of the machine including the wheels. If any type of fault or issue is detected, be sure to deal with it immediately in order to make certain the machine is running at its safest and optimum levels.