Inspect a Forklift
There are more than 10,000 workplace injuries related to forklifts happen each year, according to HRSDC and OSHA reports. A lot of these mishaps are caused by operator error. Lack of proper equipment check and maintenance causes numerous others. Forklift operation and maintenance is not just the cause of personal injuries, but also of property damage. Forklifts can damage building structures, overhead pipes and sprinklers, and other machines when wrongly operated. The following day by day inspections should be carried out in order to reduce the chance of forklift mishaps.
Before checking various fluid levels turn the engine off. Inspect these fluids: engine oil, hydraulic oil, fuel, coolant and brake fluid. The tires also have to be checked for indications of wear and tear. Check the air pressure in the tires. Check the condition of the forks. The load backrest must be securely attached. Do a visual check of the top-clip retaining heel and pin. Afterward carry out an inspection of the hydraulic hoses, mast chains, stops and cables. Ensure that the finger and overhead guards are attached securely.
LP forklifts have propane tanks that have to be checked for signs of corrosion, damage or rust. Test the battery's electrolyte levels and charge. All belts must be checked for wear. Check to make certain the owner's handbook is kept on-board the forklift in a storage compartment. Check the seat belt to make certain the latches are secure. Check the hood latch to ensure it is working as it should.
To make certain there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate at once. Check the steering controls and the accelerator. The parking break and the service break must be properly functioning.
The drive control and tilt control must be inspected to guarantee proper functioning in both forward and reverse. Test the functioning of the lowering control and hoist, and the attachment control. Check the lights and horn. After that check the heater, defroster and wipers to make sure they are functioning smoothly. Check each gauge to ascertain that it is reading within functional limits.